|
[Sponsors] |
How to set the boundary condition for temperature in the case of modeling a counter-f |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 30, 2019, 13:05 |
How to set the boundary condition for temperature in the case of modeling a counter-f
|
#1 |
New Member
AHMAD ABOULKHAIL
Join Date: Nov 2018
Location: Turkey
Posts: 9
Rep Power: 7 |
I am trying to take advantage of the periodic boundary conditions in ANSYS FLUENT program to model a small area of a heat exchanger with a counter-flow. In boundary conditions I can put the entry temperature for one fluid only but for the other fluid how we will put the temperature where it is not known !!
Please help me Note: The geometry of the exchanger towards the flow is frequent so I want to use periodic limit conditions to reduce calculation time and improve network quality. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Centrifugal fan | j0hnny | CFX | 13 | October 1, 2019 13:55 |
does Hyperthreading affect the application of UDF? | SJSW | Fluent UDF and Scheme Programming | 11 | October 10, 2018 22:28 |
how to set complex boundary condition, namely a developed velocity in inlet of pipe? | milad653279 | OpenFOAM Pre-Processing | 3 | January 4, 2016 09:46 |
External Radiation Boundary Condition (Two sided wall), Grid Interface | CFD XUE | FLUENT | 0 | July 8, 2010 06:49 |
vorticity boundary condition | bearcharge | Main CFD Forum | 0 | May 14, 2010 11:32 |