Writing Fluent Journal files Using TUI commands.

Farid2817 · September 7, 2019, 06:47

I am facing problems while writing the results using ANSYS Fluent TUI commands. Please go through the description section and attached images, please?

I was trying to extract result for wall_fuel_rod only like temperature velocity etc. However (please see the attached images), when I have entered the name of my desired surface ( wall_fuel_rod), it is demanding another surface which I do not want to add, so I pressed "Enter" button and it wants other parameters. I went through all the commands and found the result. But I need to make all the commands in a line like in a Fluent Journal file ( consisted of TUI commands ). Hence I tried but it shows error in surface (2) while I do not want to extract anything for another surface. In that case what should be my TUI commands or how can I fix the issue as I need to run the Fluent Journal file using MATLAB for Uncertainty Quantification.
Thank you.

LuckyTran · September 8, 2019, 04:18

To end a list you have to give the empty argument which is: ()
e.g.

Code:

blah blah blah "wall_fuel_rod" () blah blah blah blah blah

Also, there are no pictures... Funny, your problem didn't require any images to solve...

September 7, 2019, 06:47	Writing Fluent Journal files Using TUI commands.	#1
Farid2817 New Member Farid Ahmed Rakib Join Date: May 2018 Posts: 1 Rep Power: 0	I am facing problems while writing the results using ANSYS Fluent TUI commands. Please go through the description section and attached images, please? I was trying to extract result for wall_fuel_rod only like temperature velocity etc. However (please see the attached images), when I have entered the name of my desired surface ( wall_fuel_rod), it is demanding another surface which I do not want to add, so I pressed "Enter" button and it wants other parameters. I went through all the commands and found the result. But I need to make all the commands in a line like in a Fluent Journal file ( consisted of TUI commands ). Hence I tried but it shows error in surface (2) while I do not want to extract anything for another surface. In that case what should be my TUI commands or how can I fix the issue as I need to run the Fluent Journal file using MATLAB for Uncertainty Quantification. Thank you.

September 8, 2019, 04:18		#2
LuckyTran Senior Member Lucky Join Date: Apr 2011 Location: Orlando, FL USA Posts: 5,761 Rep Power: 66	To end a list you have to give the empty argument which is: () e.g. Code: blah blah blah "wall_fuel_rod" () blah blah blah blah blah Also, there are no pictures... Funny, your problem didn't require any images to solve...

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] SnappyHexMesh/splitMeshRegion : region1 in zone "-1"	GuiMagyar	OpenFOAM Meshing & Mesh Conversion	3	August 4, 2023 13:38
journal files and SCHEME	Hugo	FLUENT	2	October 26, 2017 10:25
[mesh manipulation] Importing Multiple Meshes	thomasnwalshiii	OpenFOAM Meshing & Mesh Conversion	18	December 19, 2015 19:57
Problem Reading Fluent Files.	Spy-k14	Tecplot	1	April 29, 2015 09:17
fluent journal files - speedup your postprocessing	warlock	FLUENT	0	March 9, 2006 00:36