|
[Sponsors] |
July 27, 2019, 08:47 |
synthetic jet
|
#1 |
Member
Join Date: Sep 2018
Posts: 31
Rep Power: 8 |
To control the recirculation zone at a diverging channel, backward-facing step geometry. I used a synthetic jet where his position is in this stage.
I found in publications that 30 periods were used for the blowing-suction of this jet and that I had also respected this condition. My problem is that in this publication, the synthetic jet takes only 0.1s so that the results converge around a gain of -24% over the distance. the initial attachment after this gain has remained fixed. Contrary to my situation, I find that the response time of my plane is too long close to 0.3 s and that the gain always increases. I averaged the CF after each period. Do you have an idea to solve this problem? |
|
Tags |
controle flow, rattchement point |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Transient Velocity Inlet (2d synthetic jet) UDF | akulagr | Fluent UDF and Scheme Programming | 4 | October 18, 2018 02:31 |
problem of the drag's convergence for a circular cylinder with a synthetic jet (udf) | bia | FLUENT | 0 | February 17, 2015 12:06 |
problems in synthetic jet flow simulation | jackxu | FLUENT | 0 | December 2, 2012 10:12 |
Synthetic (pulsatile) jet transient simulation | aero | CFX | 0 | November 6, 2009 02:10 |
inclined synthetic jet | Marouane Dghim | Main CFD Forum | 0 | July 15, 2008 10:41 |