ignition failure with both gas phase and surface mechanism

Weiqiang Liu · May 3, 2019, 12:14

Hi all,

I am doing a methane catalytic combustion simulation with fluent. For now, I can simulate cases with only surface mechanism successfully. I am trying to include both gas phase and surface mechanism in my model.

gas mechanism in my model is SK16 (16 species and 43 reactions). Surface mechanism in my model is DETHCHEM (24 reactions)

since my case is steady state, I tried to ignite the mixture with two methods.
1. Patch 2000 k to the whole computation domain.
2. give an initial high temperature to the catalytic wall and calculate for hundreds of iterations. Then set back to coupled thermal condition.

My problem is I can not ignite the mixture. The whole process is like a heat conduction from the out wall to the whole domain. By the way, the thermal condition of out wall is set as constant temperature 773K.
I attached the temperature contour below.

Can anybody give me some suggestions? Or share some strategies regarding to how to ignite the mixture?

Best.

Weiqiang

Weiqiang Liu · May 3, 2019, 21:42

a lot of researchers have done similar research. anyone who's doing similar project?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Setting the height of the stream in the free channel	kevinmccartin	CFX	12	October 13, 2022 22:43
failure of ignition when using chemkin imported thermodynamic and transport data	Weiqiang Liu	FLUENT	1	February 11, 2019 20:30
mass flow in is not equal to mass flow out	saii	CFX	12	March 19, 2018 06:21
[snappyHexMesh] Layers don't fully surround surface	EVBUCF	OpenFOAM Meshing & Mesh Conversion	14	August 20, 2012 05:31
gas phase and surface reactions	Claud	FLUENT	1	April 21, 2006 06:41

May 3, 2019, 21:42		#2
Weiqiang Liu Senior Member Weiqiang Liu Join Date: Feb 2018 Posts: 278 Rep Power: 9	a lot of researchers have done similar research. anyone who's doing similar project?