 |
 |
 |
|
|
|
[Sponsors] | ||||
Enclosure Error- Operation would result in non-manifold bodies |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 5, 2019, 13:45
|
Enclosure Error- Operation would result in non-manifold bodies
|
#1 |
|
New Member
Colin Thompson
Join Date: Feb 2019
Posts: 1
Rep Power: 0  |
I am currently modelling a geothermal earth air heat exchanger entering a room (a box). There is then a vent on the other side of the room that is attached to a solar chimney which will accelerate the air out the house.
I have modelled so far in design modeller the house attached to geothermal pipes. I was looking to test a simulation at this stage but have come across the enclosure error. As I am modelling the heat transfer to the air through the pipes and then the mixing in the room I need to create an enclosure as a fluid domain. I was hoping to then do a boolean subtraction to leave me with the domain of air to be meshed. Any advise on how to proceed would be appreciated! |
|
|
|
|
|
| Tags |
| enclosure.air.default, energy equation, fluent, non-manifold |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] Boolean creation error - operation would result in non-manifold bodies | thefinalyearkid | ANSYS Meshing & Geometry | 21 | April 8, 2022 17:48 |
| Operation would result in non-manifold bodies Error | Synchronous | FLUENT | 8 | June 15, 2017 19:11 |
| [ANSYS Meshing] Two bodies, same settings, wrong result. Please help us | StudentinANSYS | ANSYS Meshing & Geometry | 2 | February 10, 2017 05:46 |
| [DesignModeler] [ANSYS Geometry] Error: Operation would result in non-manifold bodies | -roberto | ANSYS Meshing & Geometry | 0 | April 10, 2015 07:33 |
| not getting result for natural convection in a triangular enclosure | sandeep_mtech | ANSYS Meshing & Geometry | 1 | August 8, 2010 02:50 |
Linear Mode
