|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Gil Bilang
Join Date: Oct 2018
Posts: 1
Rep Power: 0 ![]() |
Hi. I am trying to a mesoscale and microscale simulation using WRF and ANSYS. The output from WRF will be used as the boundary input for ANSYS. I was wondering though since WRF's output for wind is by grid. How do I put WRF's wind output to ANSYS? I tried reading some research journals as to how, but it left me more confused. Thank you so much!
|
|
![]() |
![]() |
![]() |
Tags |
ansys, wrf |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Running Ansys in BAtch Mode | kuleuvenstudent | ANSYS | 1 | October 18, 2017 12:11 |
[ANSYS Meshing] ANSYS mesh - I was surprised... | assafwei | ANSYS Meshing & Geometry | 0 | September 4, 2014 12:17 |
Ansys HPC licensing policy | assafwei | ANSYS | 0 | June 29, 2014 16:00 |
Using ICEM CFD to repair/edit ANSYS Meshing | Kaaji1359 | ANSYS | 2 | July 30, 2013 10:28 |
Exporting results from CFX to ANSYS ?? | sohail ahmed | CFX | 1 | December 20, 2007 01:10 |