Mesh Morpher -Deformation, How to change Parameters Values through UDF? -- CFD Online Discussion Forums

December 21, 2018, 11:01

Mesh Morpher -Deformation, How to change Parameters Values through UDF?

alasz

New Member

Join Date: Oct 2012

Posts: 1

Rep Power: 0

Hello,

I am trying to change Parameters values conected to control points in Mesh Morpher (see picture attached).

I would like to change them every timestep, I was planning to use DEFINE_AT_END, and then apply time dependend function to recalculate value that I want to give to parameter.

How can I acces those parameters through UDF?

Regards.

Attached Images

cfdonline.jpg (92.5 KB, 5 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 07:09
Change "Implicit Mesh Update Interval" using UDF	ASimonsen	Fluent UDF and Scheme Programming	2	October 12, 2017 10:38
Moving mesh	Niklas Wikstrom (Wikstrom)	OpenFOAM Running, Solving & CFD	122	June 15, 2014 07:20
Change parameters for Hybrid mesh	karananand	ANSYS Meshing & Geometry	3	July 18, 2010 17:37
How to control Minximum mesh space?	hung	FLUENT	7	April 18, 2005 10:38

All times are GMT -4. The time now is 04:35.