 |
 |
 |
|
|
|
[Sponsors] | ||||
December 7, 2018, 05:08
|
Postprocessing for free surface evaluation
|
#1 |
|
New Member
Amiya
Join Date: Aug 2017
Posts: 11
Rep Power: 9  |
I am doing a simulation of 3d vof flow over a obstacle.the channel is meshed with 15 mm and obstacle as 3.5 mm.what should be my iso surface value for water vol fraction for obtaining the free surface or to measure the height over the obstacle through probe tool.
|
|
|
|
|
|
January 12, 2019, 04:31
|
Post processing to determine height of flow
|
#2 |
|
New Member
Amiya
Join Date: Aug 2017
Posts: 11
Rep Power: 9 |
Hey, can any 1 help me that what should be my water vol fraction in Isosurface for evaluating free surface height in open channel flow?
Pls Actually in one of the videos it was aid that we should take greater fraction for low discharges and lesserfor higher discharges.can any 1 suggest why? |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Scale Surface | CellZone | OpenFOAM Post-Processing | 1 | September 2, 2016 09:29 |
| Calculating forces on a non-closed surface | ScottN | FLUENT | 0 | March 1, 2011 18:18 |
| Creating and postprocessing a rotational surface | paul_mathis | OpenFOAM Post-Processing | 2 | July 13, 2009 05:09 |
| solid edge problem....can you help? | cindy | Main CFD Forum | 3 | April 5, 2004 14:43 |
| free convection heat transfer from a heated horizontal surface through a liquid to a thin cooled fin | Kaushik | FLUENT | 1 | May 8, 2000 07:47 |
Linear Mode
