|
[Sponsors] |
optimum temperature distribution on PCB by using water medium |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 1, 2018, 07:18 |
optimum temperature distribution on PCB by using water medium
|
#1 |
New Member
Tamil Nadu
Join Date: Apr 2018
Posts: 5
Rep Power: 8 |
i am doing analysis by using ANSYS fluent software, during meshing i am getting error message like this " The mesh file exporter could not resolve cyclic dependencies in overlapping contact regions. please try to repair overlapping contact regions.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Strange temperature distribution in Three-dimensional square tube two-phase flow | who_am_I | FLUENT | 0 | April 10, 2018 09:07 |
Multiphase flow - incorrect velocity on inlet | Mike_Tom | CFX | 6 | September 29, 2016 01:27 |
Water liquid to vapor mass transfer, below boiling temperature | MGabr | FLUENT | 0 | April 20, 2015 09:11 |
Temperature Distribution on a circuit board | Blackadder | Main CFD Forum | 1 | March 27, 2003 11:32 |
uptodate water distribution network | fredius,magige,tanzanian,(e.a) | Main CFD Forum | 0 | January 27, 2002 07:10 |