how to get thrust and torque from fluent acting on propeller using single enclosure

Naveen Kumar Gulla · April 12, 2018, 05:11

how to get thrust and torque from fluent acting on propeller using single enclosure??

vasava · April 12, 2018, 08:51

In Fluent you can calculate Moments using Force Reports. The net value for Total (Pressure+Viscous)should be torque.

Naveen Kumar Gulla · April 12, 2018, 08:59

I'm using a single enclosure model, and I have created an inlet, outlet, and far-field domain as named selections but in the result, I'm getting some extra walls and while checking the report each wall is showing different Thrust and torque values, how to know which wall represents the propeller

April 12, 2018, 05:11	how to get thrust and torque from fluent acting on propeller using single enclosure	#1
Naveen Kumar Gulla New Member Naveen Kumar Gulla Join Date: Jan 2018 Posts: 28 Rep Power: 8	how to get thrust and torque from fluent acting on propeller using single enclosure??

April 12, 2018, 08:51		#2
vasava Senior Member Paritosh Vasava Join Date: Oct 2012 Location: Lappeenranta, Finland Posts: 732 Rep Power: 23	In Fluent you can calculate Moments using Force Reports. The net value for Total (Pressure+Viscous)should be torque. Last edited by vasava; April 12, 2018 at 08:53. Reason: typo

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Calculation of thrust and torque for propeller	aeksberde	OpenFOAM Post-Processing	2	October 28, 2019 06:23
Fluent Propeller Simulation	NGH	FLUENT	6	May 14, 2018 01:16
calculate the thrust and torque of a propeller in open water condition.	Alex song	STAR-CCM+	14	August 3, 2016 12:54
Thrust and torque of a propeller	Alex H	FLUENT	3	July 1, 2016 18:00
Propeller torque	Alex H	FLUENT	1	November 1, 2006 07:18

April 12, 2018, 08:59		#3
Naveen Kumar Gulla New Member Naveen Kumar Gulla Join Date: Jan 2018 Posts: 28 Rep Power: 8	I'm using a single enclosure model, and I have created an inlet, outlet, and far-field domain as named selections but in the result, I'm getting some extra walls and while checking the report each wall is showing different Thrust and torque values, how to know which wall represents the propeller