 |
 |
 |
|
|
|
[Sponsors] | ||||
February 24, 2018, 04:50
|
No rise in temperature
|
#1 |
|
New Member
Nandan Sarkar
Join Date: Feb 2018
Posts: 1
Rep Power: 0  |
Hi, I am performing simulation of a flow through a pipe. The diameter is 7 cm and length 1 m. In the model, energy is turned on, and turbulent enhanced wall function. The boundary conditions are the inlet flow velocity of 0.2 m s-1, inlet temperature of 300 K, outlet is pressure outlet and wall heat flux of 1000 W m-2. After calculations, the temperature at the outlet is just 300.2 K. Please tell me what am I going wrong?
|
|
|
|
|
 |
| Tags |
| fluent |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem with zeroGradient wall BC for temperature - Total temperature loss | cboss | OpenFOAM | 12 | October 1, 2018 07:36 |
| heat transfer coefficient value in floefd | jason kid | FloEFD, FloWorks & FloTHERM | 10 | October 16, 2016 17:55 |
| Free stream temperature in tube wall | saharesobh | FLUENT | 2 | November 19, 2012 08:32 |
| What does uniform temperature rise mean for thermal stress analysis? | Sargam05 | OpenFOAM | 4 | September 22, 2012 22:00 |
| Temperature in vessel during throttling process | Astrid | Main CFD Forum | 2 | January 31, 2001 03:34 |
Linear Mode
