Error: Divergence detected in AMG solver: epsilon

willisk15 · December 19, 2017, 15:37

Hello,
I am simulating sea water flowing through a perforated plate. I am using the VOF model, and the Reynolds Stress model (default options). I keep getting results that look like what's shown in the picture, and the error message is "Error: Divergence detected in AMG solver: epsilon". I've poured through many forum posts and fluent manuals, and I still can't figure out why this is happening. Thank you in advance! (Blue is air, red is water)

vasava · December 20, 2017, 03:06

Could you check where is this error occurring? Have you put any operating density, if not try that and see how it goes.

willisk15 · December 20, 2017, 16:42

I'm not sure what you mean by check where the error is occurring. I have the operating density set to that of air. I've already simulated the same case using the k-epsilon model, and I tried to use the same inputs to run the RSM case. Is this a bad idea? I've been trying to find resources that will help me set up the simulation using RSM, but still no luck

.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Two Phase Flow In Vertical Pipe	stonepreston	FLUENT	2	October 31, 2017 09:35
fluent divergence for no reason	sufjanst	FLUENT	2	March 23, 2016 17:08
Divergence detected in AMG solver: pressure correction	aja1345	FLUENT	3	September 2, 2015 00:58
Divergence detected in AMG solver: pressure coupled	n.jithin.1991	FLUENT	6	January 5, 2014 12:43
Error: Divergence detected in AMG solver: x-momentum/ epsilon/ temperature	bubuchacha	FLUENT	6	February 26, 2013 04:30

December 20, 2017, 03:06		#2
vasava Senior Member Paritosh Vasava Join Date: Oct 2012 Location: Lappeenranta, Finland Posts: 732 Rep Power: 23	Could you check where is this error occurring? Have you put any operating density, if not try that and see how it goes.

December 20, 2017, 16:42		#3
willisk15 New Member William Foltz Join Date: Oct 2017 Posts: 6 Rep Power: 9	I'm not sure what you mean by check where the error is occurring. I have the operating density set to that of air. I've already simulated the same case using the k-epsilon model, and I tried to use the same inputs to run the RSM case. Is this a bad idea? I've been trying to find resources that will help me set up the simulation using RSM, but still no luck .