|
[Sponsors] |
simulation in laminar convective heat transfer |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Senior Member
teguh hady
Join Date: Aug 2009
Location: Saga, Japan
Posts: 222
Rep Power: 18 ![]() |
Dear all,
I am sorry to ask silly question. I am trying to simulate convective heat transfer in laminar flow by Using Ansys FLUENT 17.2. Here is some details •Plain tube •Laminar flow (Velocity: 0.01209669 m/s) •Working fluid: water liquid •Internal diameter tube=15.88 mm •Tube length =8.02 m (7.9 m is entrance region and 0.12 m is the test section) •Inlet Temperature = 27 C •Wall Temperature = 17 C •Reference Temperature = Film Temperature = 22 C •All Properties are calculated at Film Temperature But the result is not good. The velocity and temperature profile should be parabolic. I attach some of results. Do you have any suggestion? Thank you so much
__________________
Now Or Never!!! ![]() |
|
![]() |
![]() |
![]() |
Tags |
heat transfer, laminar, plain pipe |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
a natural convective heat transfer problem | mariashva | FLUENT | 34 | August 22, 2017 20:57 |
CFD simulation and heat transfer of gap flow in rectangular duct | marv91 | OpenFOAM Running, Solving & CFD | 0 | April 17, 2017 09:11 |
Separate Convective and Radiative heat transfer in CFD post using fluent as a solver | Lemanes | FLUENT | 1 | July 6, 2015 10:31 |
Convective heat loss out of a solar receiver construction | Lionel Trébuchon | CFX | 10 | April 6, 2014 20:25 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |