 |
 |
 |
|
|
|
[Sponsors] | ||||
December 4, 2017, 05:03
|
Dynamic meshing
|
#1 |
|
New Member
Douaa Al-Assaad
Join Date: Feb 2017
Posts: 9
Rep Power: 9  |
Hello everyone,
I am currently simulating a walking human being in ANSYS Fluent. It has worked so far if i raise the manikin off the floor (10 cm), however, when I lower the manikin to floor level (1 cm), the negative cell volume problem appears. Is there anyway to lower the object to the floor and simulate walking without obtaining this error? Thank you |
|
|
|
|
 |
| Tags |
| dynamic meshing |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CFD simulation of gas cicrcuit breaker in fluent with dynamic meshing. | Mahesh7238 | FLUENT | 1 | April 5, 2021 01:21 |
| Dynamic Meshing of Simple 2D Geometry | harman79 | FLUENT | 2 | January 17, 2018 07:07 |
| UDF for dynamic meshing? | prasaddeole | FLUENT | 2 | October 6, 2014 12:55 |
| negative cell volume during dynamic meshing | Tamjid | FLUENT | 1 | September 5, 2011 03:33 |
| [GAMBIT] Dynamic Meshing of a combustion chamber | donarundas | ANSYS Meshing & Geometry | 1 | December 2, 2009 08:13 |
Linear Mode
