|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Barbara
Join Date: Jan 2017
Posts: 2
Rep Power: 0 ![]() |
Hi everybody!
I'm trying to simulate the interface between a porous medium and a fluid, for a natural convection problem. I've two different domain and I have to set the interface between them. The problem is that I have temperature anomalies at the interface that are not realistic (like -20°C when I'm working with temperatures close to 0°C). I've tried to refine the mesh at the interface and to change the interface type...but nothing... Do you have some suggestions? Thank you very much!! Barbara |
|
![]() |
![]() |
![]() |
Tags |
interface |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
fluid porous interface | NewGuy | CFX | 8 | February 20, 2017 23:04 |
Error in Two phase (condensation) modeling | adilsyyed | CFX | 15 | June 24, 2015 19:42 |
Modeling interface of fluid and porous, not with default setting | ftab | CFX | 27 | May 20, 2014 06:58 |
Interface setup for fluid & porous zones | siw | FLUENT | 0 | December 22, 2011 07:39 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |