 |
 |
 |
|
|
|
[Sponsors] | ||||
November 1, 2017, 08:00
|
Velocity inlet BC profile
|
#1 |
|
New Member
Antonio
Join Date: Jun 2017
Posts: 9
Rep Power: 9  |
I'm having problem with the definition of boundary conditions thorugh profile data.
The .dat file is uploaded well (image attached). I choose "components" as velocity inlet, then i choose this profile as axial velocity inlet (the same for tangential and radial, with other profiles). After initializating, when I plot the axial profile (contour plot) the maximum velocity is lower than in the profile boundary condition (around 3 m/s in the boundary, 1.3 m/s in the contour plot) Why the velocity at the boundary isn't what it sould be? |
|
|
|
|
|
November 1, 2017, 15:22
|
|
#2 |
|
New Member
Antonio
Join Date: Jun 2017
Posts: 9
Rep Power: 9 |
Problem solved, the "r" distance should be specified in meters and not in mm
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [swak4Foam] Inlet velocity profile for turbulent pipe flow using swak4Foam | zordiack | OpenFOAM Community Contributions | 5 | February 23, 2016 02:52 |
| Setting velocity profile at the inlet using codedFixedValue | CTR | OpenFOAM Pre-Processing | 1 | May 20, 2014 13:01 |
| extracting outlet velocity profile from one case to another case's inlet | tonggysun | OpenFOAM | 2 | September 13, 2013 05:19 |
| Velocity profile at inlet | siw | CFX | 2 | May 3, 2012 10:30 |
| Export & Import Velocity profile as Inlet | eRzBeNgEl | STAR-CCM+ | 6 | March 26, 2012 06:16 |
Linear Mode
