 |
 |
 |
|
|
|
[Sponsors] | ||||
Simulation of flow inside bottle at different inlet pressures. |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 12, 2017, 16:35
|
Simulation of flow inside bottle at different inlet pressures.
|
#1 |
|
New Member
Maitray sharma
Join Date: Aug 2017
Posts: 7
Rep Power: 9  |
I am trying to simulate a flow inside a bottle with sand inside it , the porosity has been defined in the cell zone condition and gas gauge pressure 16 bar at the inlet is air , density based solver is used with laminar model and energy equations on.
(Transient analysis) The problem is whenever I calculate the result , it takes 12000 iteration to solve for a single time step , and at the second iteration itself the temprature rise upto 5000 kelvin. Am i doing something wrong. Timestep size is 0.01 sec Thank you |
|
|
|
|
|
October 12, 2017, 21:14
|
|
#2 |
|
Senior Member
Alexander
Join Date: Apr 2013
Posts: 2,363
Rep Power: 34 |
16 bar at the inlet of the bottle... What is the value of flow velocity? What do you expect?
Best regards |
|
|
|
|
|
|
October 13, 2017, 00:14
|
|
#3 | |
|
New Member
Maitray sharma
Join Date: Aug 2017
Posts: 7
Rep Power: 9 |
Quote:
|
||
|
|
|
||
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Issues on the simulation of high-speed compressible flow within turbomachinery | dowlee | OpenFOAM Running, Solving & CFD | 11 | August 6, 2021 07:40 |
| Suitable inlet boundary condition for a compressible flow simulation | siw | FLUENT | 13 | October 10, 2018 00:54 |
| Mass Flow Inlet | AZ1621 | FLUENT | 5 | July 6, 2015 20:54 |
| Coupling of drying process and flow simulation | franzdrs | Main CFD Forum | 0 | April 29, 2013 15:11 |
| meshing F1 front wing | Steve | FLUENT | 0 | April 17, 2003 13:37 |
Linear Mode
