[AliMosayyebi]

Hello there,

I am using the following versions:
ANSYS WorkBench 2018
FLUENT 2018
ICEM 2018

I have created mesh files using ICEM in different sizes of mesh. the purpose is to perform mesh dependence study using ANSYS workbench all in one run.

so, what I mean is to put all mesh files in a single foulder and then set a single FLUENT simulation to perform mesh dependence study for one flow rates using all mesh files in parallel or series. And software creates automatically a cfd post file that includes data results of all calculations.


after I am planning to choose the best mesh file and run a simulation using all inlet flow rates, which I set them as parameters.

I would like to perform something like a parameter sweep, in which I only press the button once and then get data at the end all together rather than finishing a simulation, saving it and chaning flow rate or mesh and run new one and so on and so forth.

Best,
Ali