 |
 |
 |
|
|
|
[Sponsors] | ||||
May 10, 2017, 19:28
|
Fluent, problem with results
|
#1 |
|
New Member
Tomas
Join Date: May 2017
Posts: 1
Rep Power: 0  |
Hello everyone! I am quite new user of Ansys. I tried to make air flow simulation over vehicle. For one model it works just fine, but for another model it is not working in same settings and I dont get any results. Geometry and mesh is fine. I use default settings. I attach model and bad results for it.
Model download link: https://drive.google.com/file/d/0B6t...ew?usp=sharing P.S Use loose tolerance in import geometry I hope to get help from you guys. |
|
|
|
|
 |
| Tags |
| anys, modeling cfd, not working, problem set-up, result |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fluent - license problem. | Marcin | FLUENT | 3 | April 13, 2018 17:33 |
| fluent subsonic wing analysis problem | fatihcoban | FLUENT | 0 | August 3, 2016 10:41 |
| fluent convergence problem | josip76 | FLUENT | 0 | May 26, 2011 21:08 |
| [ICEM] [FLUENT] 2D Geometry problem when exporting to Fluent - Unwanted walls | MikeTichondrius | ANSYS Meshing & Geometry | 1 | February 9, 2011 14:31 |
| problem about periodic boundary condition in Fluent | winnawinna | FLUENT | 0 | December 29, 2010 00:32 |
Linear Mode
