 |
 |
 |
|
|
|
[Sponsors] | ||||
getting very large value of coefficent of drag and lift for a 3d model |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 25, 2017, 00:41
|
getting very large value of coefficent of drag and lift for a 3d model
|
#1 |
|
New Member
aham
Join Date: Apr 2017
Posts: 2
Rep Power: 0  |
hello,
i am doing a small project on ansys 15 fluent but in every itration i am getting high value of Cd and Cl i have tried laminar, K-omega, K-epsillon, SST but in every model value is large.constrain are following inlet velocity 22.22 m/s outlet pressure 1atm enclosure is 6 times of body body 34inch high and 23 inch width (its rider, motortank ,seat and windshield) i also try inflation and cut cell type of mesh with 5 mm minimum size i can upload my result and model pic if someone can help please  :con fused: help
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to calculate lift, drag and lift distribution in Star CCM+? | israelcasillas94 | STAR-CCM+ | 4 | November 6, 2020 09:35 |
| wrong SU2 calculation for lift and drag coefficient for NAC4421 | mechy | SU2 | 7 | January 9, 2017 06:18 |
| Airfoil lift and drag using k-kl-omega turbulence model | hylleman | OpenFOAM Running, Solving & CFD | 6 | June 17, 2016 16:10 |
| Getting large drag and lift coefficients after running MRFSimpleFoam | western | OpenFOAM | 0 | April 1, 2013 22:35 |
| Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 04:32 |
Linear Mode
