|
[Sponsors] |
Naming conductive zones in modelling batteries |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Kumar
Join Date: Feb 2017
Posts: 1
Rep Power: 0 ![]() |
I am currently doing a project in the field of electric vehicle design.It requires me to model a lithium ion battery stack.For this I have gone through numerous tutorials including the one on Battery module from ANSYS documentation but I have not got any clear idea on how to go about naming the zones before setting up the solution.No matter how I name them during Meshing using named selections,they don't appear for selection in the Conduction zones tab of the MSMD Battery model dialog box.
So,I request you to kindly guide me through this problem.It would be very helpful for me to do the project fast.I have no other source of help. Thanking You Last edited by pmkumar1308; February 6, 2017 at 12:03. |
|
![]() |
![]() |
![]() |
![]() |
#2 | |
New Member
Join Date: May 2024
Location: Delhi
Posts: 1
Rep Power: 0 ![]() |
Quote:
|
||
![]() |
![]() |
![]() |
Tags |
battery, battery design studio, battery model, battery pack, named selections |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Setting the height of the stream in the free channel | kevinmccartin | CFX | 12 | October 13, 2022 21:43 |
CFD in Naval Hydrodynamics, Off-Shore and Wave Modelling with OpenFOAM | hjasak | OpenFOAM Announcements from Other Sources | 2 | February 13, 2017 04:59 |
[TGrid] Tgrid naming boundaries , zones | natantyt | ANSYS Meshing & Geometry | 3 | May 28, 2013 14:13 |
error message | cuteapathy | CFX | 14 | March 20, 2012 06:45 |
modelling adjacent zones | faiz rauf | FLUENT | 0 | August 17, 2004 06:53 |