Home > Forums > Software User Forums > ANSYS > FLUENT

Question about airfoil 2D simulation using Fluent

Updated Threads

Reply

Search this Thread

November 26, 2016, 08:38	Question about airfoil 2D simulation using Fluent	#1
Abdelrahman Yousry New Member Abdelrahman Yousry Join Date: Nov 2016 Posts: 1 Rep Power: 0	Hello everyone I imported a 2D airfoil geometry into the design modler, then drew a C-domain, then subtracted the airfoil surface from the domain surface. My problem is: 1) fluent identifies the domain only so i cant choose the airfoil to grow prisms 2) fluent appears to be running in 3D so whenever i start meshing it gives me "no cell zone" error Thank you

Reply

Tags

airfoil 3d, airfoil analysis, airfoil mesh, ansys, fluent

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Trying to perform test validity of Fluent with simulation of 2D airfoil	didiean	FLUENT	39	December 5, 2015 14:31
Question about starting the simulation automatically one after another by Fluent	Anna Tian	FLUENT	1	January 23, 2014 20:23
How to read or write case by commands during simulation with Fluent	lzgwhy	FLUENT	4	April 20, 2011 23:02
Simulation of a moving airfoil in Fluent	M.Sc_Student	FLUENT	2	October 25, 2010 04:03
New Fluent Remote Simulation Facility	Paul Bemis	FLUENT	8	July 2, 2002 10:18

All times are GMT -4. The time now is 12:40.