Boundary Conditions for Open Environment

rahagir · November 7, 2016, 17:48

Hi,

I am working on a project called spray cooling system of hot water. I am trying to run a simulation for it with ANSYS Fluent but i'm stuck with my boundary conditions. I am not sure what should be appropriate boundary conditions for an open environment at certain temperature and humidity level.

Please, I need help with this. I am new to ANSYS and I have very limited knowledge.

I am currently using ANSYS workbench 14.5.

oozcan · November 9, 2016, 07:49

Please clarify little bit

November 7, 2016, 17:48	Boundary Conditions for Open Environment	#1
rahagir New Member Rahagir Join Date: Oct 2016 Posts: 3 Rep Power: 10	Hi, I am working on a project called spray cooling system of hot water. I am trying to run a simulation for it with ANSYS Fluent but i'm stuck with my boundary conditions. I am not sure what should be appropriate boundary conditions for an open environment at certain temperature and humidity level. Please, I need help with this. I am new to ANSYS and I have very limited knowledge. I am currently using ANSYS workbench 14.5.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Multiphase flow - incorrect velocity on inlet	Mike_Tom	CFX	6	September 29, 2016 02:27
Error - Solar absorber - Solar Thermal Radiation	MichaelK	CFX	12	September 1, 2016 06:15
Basic Nozzle-Expander Design	karmavatar	CFX	20	March 20, 2016 09:44
Low Mixing time Problem	Mavier	CFX	5	April 29, 2013 01:00
Water subcooled boiling	Attesz	CFX	7	January 5, 2013 04:32

November 9, 2016, 07:49		#2
oozcan Senior Member Onur Özcan Join Date: Feb 2016 Location: Istanbul/Turkey Posts: 461 Rep Power: 12	Please clarify little bit