|
[Sponsors] |
August 31, 2016, 16:05 |
Trying to match Pressure Profile
|
#1 |
New Member
Fraser
Join Date: Aug 2016
Posts: 1
Rep Power: 0 |
Looking for advice on how to handle this problem I'm working on.
I have a pressure profile around a blade from an infinite cascade simulation. Now I need to add walls for a test section that will replicate the pressure profile around the blade. My intent was to use the mesh morpher or adjoint solver to magically match the profile, but apparently that requires writing a UDF to compare the profiles(?) Is there an easier way to match the profiles or will I need to learn UDF? Fraser |
|
Tags |
compare, fluent, profile, udf |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind tunnel Boundary Conditions in Fluent | metmet | FLUENT | 6 | October 30, 2019 13:23 |
"Pressure Inlet" Boundary Setup | Wijaya | FLUENT | 15 | May 18, 2016 11:08 |
Questions on a pressure profile | saisanthoshm88 | FLUENT | 1 | March 29, 2013 05:59 |
Gas pressure question | Dan Moskal | Main CFD Forum | 0 | October 24, 2002 23:02 |
Hydrostatic pressure in 2-phase flow modeling (long) | DS & HB | Main CFD Forum | 0 | January 8, 2000 16:00 |