 |
 |
 |
|
|
|
[Sponsors] | ||||
August 12, 2016, 06:43
|
Liquid setting of material in VOF model
|
#1 |
|
New Member
YongHanLee
Join Date: Aug 2015
Posts: 3
Rep Power: 11  |
Dear all,
I use VOF model to simulate titanium centrifugal casting. I have to set titanium as liquid state, which means molten metal. but FLUENT only allow me to set material as FLUID. I think fluid means both gas state and liquid state. So FLUID state is not specific. Also, I found there are two state of water in FLUENT, liquid and vapor. What's the differences between water-liquid and water-vapor except water-material properties? Thank you all. regards, Dox Kim |
|
|
|
|
 |
| Tags |
| fluent, liquid, vof |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Setting the height of the stream in the free channel | kevinmccartin | CFX | 12 | October 13, 2022 22:43 |
| Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 04:32 |
| urgent... multiphase cfd model of packed bed reactor.( VOF MODEL using) | balu@gold6 | FLUENT | 4 | July 26, 2012 11:37 |
| error message | cuteapathy | CFX | 14 | March 20, 2012 07:45 |
| Warning 097- | AB | Siemens | 6 | November 15, 2004 05:41 |
Linear Mode
