|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Join Date: Jul 2016
Posts: 4
Rep Power: 10 ![]() |
Hello everyone,
I would like to calculate the Pope criterion of my LES simulation in Fluent 16.0, but I can not access the RMS fluctuation velocities with this version. Could you tell me how to get the Pope criterion please ? Thanks in advance Gemaak |
|
![]() |
![]() |
![]() |
![]() |
#2 |
New Member
Join Date: Jul 2016
Posts: 4
Rep Power: 10 ![]() |
Anyone would know That ?
Or how to get the RMS in FLUENT 16.0 ? |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 04:22 |
heat transfer with RANS wall function, over a flat plate (validation with fluent) | bruce | OpenFOAM Running, Solving & CFD | 6 | January 20, 2017 07:22 |
[ANSYS Meshing] fluent cutcell grid and skeweness criterion | laxwendrofzx9r | ANSYS Meshing & Geometry | 4 | June 3, 2012 12:45 |
Fluent 6.3 32bit vs Fluent 12.0 64bit | ibex7 | FLUENT | 7 | April 18, 2011 03:44 |
Fluent 12.0 is worst then Fluent 6.2 | herntan | FLUENT | 5 | December 14, 2009 03:57 |