Home > Forums > Software User Forums > ANSYS > FLUENT

zero or very small amount of water saturation in my fuel cell simulation

Updated Threads

Reply

Search this Thread

July 2, 2016, 23:11	zero or very small amount of water saturation in my fuel cell simulation	#1
kobe bryant New Member Join Date: Jul 2016 Posts: 8 Rep Power: 10	I was working on simulation about proton exchange membrane fuel cell under steady operating conditions.In my simulation results,I got some results like water content,mass faction of gas,current density.But there is zero or appximately zero water saturation.I tried a lot times and found no reason.Please help me.And i have setted anode and cathode inlet water saturation is specified value zero.looking forward to your reply

Reply

Tags

fuel cell water

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
UDS equation for liquid water saturation in porous media	Rui_27	Fluent UDF and Scheme Programming	11	September 19, 2017 21:44
Solar Panel Water heating using solidwork Flow Simulation	axtray	FloEFD, FloWorks & FloTHERM	2	September 21, 2011 16:47
Cells with t below lower limit	Purushothama	Siemens	2	May 31, 2010 22:58
Molten Carbonate Fuel Cell simulation	MASOUD	FLUENT	0	October 5, 2009 00:40
Terrible Mistake In Fluid Dynamics History	Abhi	Main CFD Forum	12	July 8, 2002 10:11

All times are GMT -4. The time now is 07:01.