 |
 |
 |
|
|
|
[Sponsors] | ||||
June 30, 2016, 00:57
|
CFD for a water tank using FLUENT
|
#1 |
|
New Member
Vivek Yadav
Join Date: Jun 2016
Location: Kathmandu
Posts: 1
Rep Power: 0  |
I have been trying doing CFD analysis of a water whose jpj file I have attached. While calculation on SET UP it shows an error of divergence found in AMG; Temperature. I am not able to rectify the problem please hel me out
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Keeping inlet mass flux the same as outlet mass flux in an water tank | vaibhav402 | Main CFD Forum | 0 | October 13, 2015 04:02 |
| Setting Up a case on building an empty tank with water going into the tank | Nori4U | OpenFOAM Programming & Development | 1 | May 8, 2015 03:10 |
| Water tank baffles - modeling the flow with tank half full | A_Prakash | CFX | 11 | January 1, 2015 11:43 |
| Fluent CFD vs Fluent CFX | gpan | FLUENT | 0 | December 21, 2011 14:09 |
| Dimension conflict between icem cfd and fluent | highhopes | ANSYS Meshing & Geometry | 1 | September 9, 2011 12:07 |
Linear Mode
