 |
 |
 |
|
|
|
[Sponsors] | ||||
June 6, 2016, 17:38
|
How to get an additional quantities in UDF
|
#1 |
|
New Member
Karnauhov Valery
Join Date: Dec 2013
Posts: 20
Rep Power: 12  |
good day,
my question is next. In Fluent there is an ability to add additional quantities to .dat file ("Data File Quantities..." button in "Run Calculation" tab). Herewith in .dat file appear bars with new quantities. In UDF I can use STORAGE-procedures to get necessery values (e.g F_STORAGE_R_N3V or C_STORAGE_R). In .dat file this values denoted by SV_-symbols, but additional quantities have not SV_ mark and denotes simple by their name (e.g "viscosity-ratio"). How can I get accses for them? Very apologize for my bad english, best regards. |
|
|
|
|
 |
| Tags |
| fluent - udf, storage variables |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Source Term UDF VS Porous Media Model | pchoopanya | Fluent UDF and Scheme Programming | 1 | August 28, 2013 07:12 |
| Help me to check my UDF | Liufeng_ustb | Fluent UDF and Scheme Programming | 2 | May 7, 2013 11:25 |
| Exporting Solution Data - UDF quantities | mark- | Fluent UDF and Scheme Programming | 1 | March 14, 2013 09:55 |
| Simulation with UDF for species mass fraction and velocity profile | virgy | Fluent UDF and Scheme Programming | 8 | February 7, 2012 05:30 |
| UDF programming | fullmonty | FLUENT | 5 | June 30, 2011 03:40 |
Linear Mode
