 |
 |
 |
|
|
|
[Sponsors] | ||||
April 29, 2016, 11:38
|
Improve the mesh quality
|
#1 |
|
New Member
Liu
Join Date: Apr 2016
Posts: 2
Rep Power: 0  |
Hallo, everyone.
I want to make a simulation for the fluid flow in a planar-SOFC. But after i imported the mesh data in Fluent, check the mesh quality, the quality of mesh is so poor. Minimum Orthogonal Quality = 7.23343e-04 (Orthogonal Quality ranges from 0 to 1, where values close to 0 correspond to low quality.) Warning: minimum Orthogonal Quality below 0.01. Maximum Ortho Skew = 9.99277e-01 (Ortho Skew ranges from 0 to 1, where values close to 1 correspond to low quality.) So how can i improve the mesh quality?  Can someone help me in this?! Thanks in advance. Zhang |
|
|
|
|
|
April 30, 2016, 13:20
|
|
#2 |
|
New Member
Liu
Join Date: Apr 2016
Posts: 2
Rep Power: 0 |
Can someone help me in this?!
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] How To Improve Pre Mesh Quality In O grid Based Double Pipe Cylinder | Shomaz ul Haq | ANSYS Meshing & Geometry | 6 | January 15, 2018 07:38 |
| [ICEM] Heart modeling - ICEM Hexa Mesh quality improvement | heart_modeller | ANSYS Meshing & Geometry | 1 | April 8, 2016 09:16 |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 10:38 |
| [Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 04:52 |
| Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 19:10 |
Linear Mode
