[yusuf.5ayat]

Hello,

I have a probelm that I have to simulate urgently.

The problem is a tank with a diameter of 400mm and total length of 2m. Part of this tank is a sieve (let's say at a heigh of 600mm from the feed nozzel of the tank) with the same diameter of the tank 400mm. The probelm is the sieve!

How can I simulate the sieve, shall I use porous media as an approach (Eventhough I don't know the porosity coffiecents,ect) and shall I put boundary conditions for the sieve or ansys assumes that automatically since there must be a cetrain amount of flow that goes through the sieve.

Any help will be highly appreicated.

Best Regards,
Yousef