|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Yang
Join Date: Jun 2015
Posts: 25
Rep Power: 11 ![]() |
My mesh's avg. orthogonal quality is .8 but minimum is .02. I used hex dominant and sizing functions. The surface elements look good. I have a cavity in the mesh, so I don't know where this bad element is. Wireframe view hurts my eyes. Is there a way to find it without eyeballing? Thank you.
|
|
![]() |
![]() |
![]() |
Tags |
orthogonal, quality |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Orthogonal Quality Issues | simondpowell | Mesh Generation & Pre-Processing | 6 | September 5, 2020 03:04 |
Improve Orthogonal Quality within Fluent | ptstorey | FLUENT | 8 | August 3, 2015 12:57 |
Low orthogonal quality after gradient adaptation | herrolsen | FLUENT | 1 | May 11, 2015 13:40 |
[ICEM] Different Orthogonal Quality in ICEM and FLUENT | Thibalt | ANSYS Meshing & Geometry | 4 | February 27, 2015 05:45 |
[ANSYS Meshing] Orthogonal Quality Issues in the Infalation Layer | B737200 | ANSYS Meshing & Geometry | 3 | October 4, 2014 06:10 |