|
[Sponsors] |
In symmetric geometry results are not symmetric. |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
vikas yadav
Join Date: Jul 2015
Posts: 9
Rep Power: 11 ![]() |
I need some advice ... i am doing 3d simulations of heat transfer in microchannel heat sink.
Heat sink is symmetric from centre of inlet to centre of outlet. But i am not getting symmetrical results. Any suggestions where i might be doing wrong. your advice will be very helpful. |
|
![]() |
![]() |
![]() |
![]() |
#2 |
New Member
vikas yadav
Join Date: Jul 2015
Posts: 9
Rep Power: 11 ![]() |
your advice will be very helpful
|
|
![]() |
![]() |
![]() |
Tags |
results, symmetrical |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] 2D mesh from a 3D geometry results in 1m thick mesh | herrolsen | ANSYS Meshing & Geometry | 2 | March 26, 2019 15:00 |
Comparing Air numerical results with water experimental results | cristian2009es | Main CFD Forum | 1 | July 2, 2014 18:11 |
tet results vs hex results | sivakumar | OpenFOAM Running, Solving & CFD | 0 | March 4, 2014 10:15 |
[DesignModeler] Error while Loading a Geometry | JD944 | ANSYS Meshing & Geometry | 0 | October 25, 2011 14:51 |
[Gmsh] Problem meshing an imported geometry | Alicia | OpenFOAM Meshing & Mesh Conversion | 0 | March 30, 2010 04:53 |