Heat transfer of fluid in radiator tube and fin

Muhey · May 28, 2015, 03:09

Hi guys..
I need help and advise in simulating the fluid flow in single tube and fins of car radiator using k-epsilon turbulence model.
I'm still new and beginner in CFD and using fluent software. I'm doing so far referring to the tutorial and steps taken in this analysis.

The geometry is done using solidworks which later transfer to workbench(fluent).
Fluid at inlet :
mass flow rate = 0.001kg/s
temperature=351K

Here I attach picture for reference on what i have been doing so far..
Hope you guys can help me point out where the mistake.

1.mesh.jpg

2.mesh quality.jpg

3.Boundary Condition.jpg

4.inlet.PNG

5.plot.jpg

edoan · May 28, 2015, 15:10

Hey muhey, one place to start solving your problems is improving your mesh quality. You have a very low orthagonality and the aspect ratio is quite large.

Muhey · June 5, 2015, 03:48

Quote:

Originally Posted by edoan

Hey muhey, one place to start solving your problems is improving your mesh quality. You have a very low orthagonality and the aspect ratio is quite large.

Thanks for the advise edoan..Can you suggest how to do that? Is it ok if i proceed and improve the current method or there is another better method to get better quality of the mesh?

May 28, 2015, 03:09	Heat transfer of fluid in radiator tube and fin	#1
Muhey New Member muhaimin Join Date: May 2015 Posts: 7 Rep Power: 11	Hi guys.. I need help and advise in simulating the fluid flow in single tube and fins of car radiator using k-epsilon turbulence model. I'm still new and beginner in CFD and using fluent software. I'm doing so far referring to the tutorial and steps taken in this analysis. The geometry is done using solidworks which later transfer to workbench(fluent). Fluid at inlet : mass flow rate = 0.001kg/s temperature=351K Here I attach picture for reference on what i have been doing so far.. Hope you guys can help me point out where the mistake. 1.mesh.jpg 2.mesh quality.jpg 3.Boundary Condition.jpg 4.inlet.PNG 5.plot.jpg

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to calculated the Heat Transfer Coefficent of Fin	alokphulpagar	ANSYS	0	January 29, 2010 01:02
Calculate the heat transfer coeficient of a fin H	Christos	Siemens	4	February 23, 2009 17:56
flow/heat transfer through heat sink (with fins)?	Pei-Ying Hsieh	Main CFD Forum	1	January 26, 2008 07:33
duct fin system with conjugate heat transfer	Dibakar Rakshit	FLUENT	0	July 3, 2003 00:56
free convection heat transfer from a heated horizontal surface through a liquid to a thin cooled fin	Kaushik	FLUENT	1	May 8, 2000 07:47

May 28, 2015, 15:10		#2
edoan Member Ethan Doan Join Date: Oct 2012 Location: Canada Posts: 90 Rep Power: 14	Hey muhey, one place to start solving your problems is improving your mesh quality. You have a very low orthagonality and the aspect ratio is quite large.