Input 2 fluids through same inlet

lakshmi.bala · May 16, 2015, 12:51

Hi

I am trying to simulate a simple interaction between 2 miscible fluids. I have a single inlet and I would like to input 2 fluids through this inlet in such a way that the lower half contains 1 fluid while the upper half has another fluid. Could someone help me check how to do the same?

Thanks in advance
Lakshmi

mnolan93 · May 16, 2015, 12:56

what are you using to model your geometry?

lakshmi.bala · May 16, 2015, 22:22

Hi Martin

I have been using fluent design modeler to model my geometry.

Thank you for your help
Best regards
Lakshmi

Bharadwaj B S · May 18, 2015, 03:26

You can just split the inlet surface into two inlets and give different fluids.

lakshmi.bala · May 18, 2015, 04:52

Ok i managed to make it work. Thank you fro your help

Bharadwaj B S · May 18, 2015, 05:05

Great to hear. Good luck

May 16, 2015, 12:51	Input 2 fluids through same inlet	#1
lakshmi.bala New Member Lakshmi Join Date: Apr 2015 Posts: 6 Rep Power: 11	Hi I am trying to simulate a simple interaction between 2 miscible fluids. I have a single inlet and I would like to input 2 fluids through this inlet in such a way that the lower half contains 1 fluid while the upper half has another fluid. Could someone help me check how to do the same? Thanks in advance Lakshmi

May 18, 2015, 03:26	Easy way	#4
Bharadwaj B S Member Baradwaj B S Join Date: Jan 2015 Posts: 75 Rep Power: 11	You can just split the inlet surface into two inlets and give different fluids.

May 18, 2015, 05:05	Great	#6
Bharadwaj B S Member Baradwaj B S Join Date: Jan 2015 Posts: 75 Rep Power: 11	Great to hear. Good luck

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
2D Hypersonic Inlet in FLUENT - Convergence Issues	Fraisdegout	FLUENT	6	December 15, 2016 03:07
Problem with assigned inlet velocity profile as a boundary condition	Ozgur_	FLUENT	5	August 25, 2015 05:58
TimeVaryingMappedFixedValue for Direct Numerical Simulation inlet	johndeas	OpenFOAM	5	May 21, 2014 08:11
[swak4Foam] Trouble setting groovyBC interFoam Inlet BC	mgdenno	OpenFOAM Community Contributions	4	July 1, 2012 09:16
How to set up the inlet boundary condition for a low pressure case?	beastieboys6	FLUENT	3	April 10, 2012 23:46

May 16, 2015, 12:56		#2
mnolan93 Member Martin Nolan Join Date: Dec 2014 Posts: 33 Rep Power: 11	what are you using to model your geometry?

May 16, 2015, 22:22		#3
lakshmi.bala New Member Lakshmi Join Date: Apr 2015 Posts: 6 Rep Power: 11	Hi Martin I have been using fluent design modeler to model my geometry. Thank you for your help Best regards Lakshmi

May 18, 2015, 04:52		#5
lakshmi.bala New Member Lakshmi Join Date: Apr 2015 Posts: 6 Rep Power: 11	Ok i managed to make it work. Thank you fro your help