shell conduction model

amin.z · April 16, 2015, 02:28

hey friend

can shell conduction model be used in parallel mode!?

ghost82 · April 16, 2015, 17:24

Yes, I think so..I used it for the computation of a tube in tube heat exchanger without problems..why this question? Did you read somewhere that it cannot be used in parallel?

amin.z · April 18, 2015, 04:23

When I used parallel setup, fluent said fatal error and crashed! but when run on serial setup it works very well!
I've checked several settings but haven't succeed...

ghost82 · April 18, 2015, 10:49

Ok, the error should be related to something else, not to shell conduction/parallel calculation.
Did you try to disable shell conduction and run in parallel?Did you get the same error?
If you want to share the cas I can try to run it on my pc to see if the error is due to ansys installation..you have my email.

Daniele

amin.z · April 18, 2015, 10:52

Tnx friend!
ya, it's working normally without shell conduction in parallel mode,
I'm performing some modification in the model for new run, if the problem doesn't solved, I will share it with you

tnx for your kindness support

April 16, 2015, 02:28	shell conduction model	#1
amin.z Senior Member Amin Join Date: Oct 2013 Location: Germany Posts: 397 Rep Power: 15	hey friend can shell conduction model be used in parallel mode!?

April 16, 2015, 17:24		#2
ghost82 Senior Member Rick Join Date: Oct 2010 Posts: 1,016 Rep Power: 27	Yes, I think so..I used it for the computation of a tube in tube heat exchanger without problems..why this question? Did you read somewhere that it cannot be used in parallel? __________________ Google is your friend and the same for the search button!

April 18, 2015, 10:49		#4
ghost82 Senior Member Rick Join Date: Oct 2010 Posts: 1,016 Rep Power: 27	Ok, the error should be related to something else, not to shell conduction/parallel calculation. Did you try to disable shell conduction and run in parallel?Did you get the same error? If you want to share the cas I can try to run it on my pc to see if the error is due to ansys installation..you have my email. Daniele __________________ Google is your friend and the same for the search button!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Shell Knock model for NG combustion	cfdvenkatesh	AVL FIRE	0	June 24, 2014 20:11
shell conduction (urgent)	muhittin	FLUENT	4	September 24, 2013 04:30
coupled field in shell model analysis	chenwen521	ANSYS	0	September 28, 2009 23:32
Shell Ignition Model	Felix	Main CFD Forum	0	February 10, 2006 01:40
Shell conduction and Conjugate problem	RBM	FLUENT	1	October 24, 2005 13:20

April 18, 2015, 04:23		#3
amin.z Senior Member Amin Join Date: Oct 2013 Location: Germany Posts: 397 Rep Power: 15	When I used parallel setup, fluent said fatal error and crashed! but when run on serial setup it works very well! I've checked several settings but haven't succeed...

April 18, 2015, 10:52		#5
amin.z Senior Member Amin Join Date: Oct 2013 Location: Germany Posts: 397 Rep Power: 15	Tnx friend! ya, it's working normally without shell conduction in parallel mode, I'm performing some modification in the model for new run, if the problem doesn't solved, I will share it with you tnx for your kindness support