negative volume ..,mesh update failed

wolverine · April 15, 2015, 05:59

i have been encountering this pbm . my case is a sinusoidal accelerated boundary wall .. is there any specific criteria to enhance the meshing ?

pumpkin · April 15, 2015, 08:04

Try setting a really small time step, so that the mesh does not move more than a single cell.

wolverine · April 15, 2015, 11:23

i tried lower time steps.. will mesh morphing helps??

pumpkin · April 16, 2015, 05:08

I'm not sure mesh morphing will help.

I suggest you to check where are your negative volumes. Try doing a plot of volume (with different iso-values).

Then check if there are some left-handed cells. If so, I think you can repair them with in the command line with /grid/modify-zones/repair-face-handedness

Hope this helps.

April 15, 2015, 05:59	negative volume ..,mesh update failed	#1
wolverine New Member logan Join Date: Feb 2012 Posts: 10 Rep Power: 14	i have been encountering this pbm . my case is a sinusoidal accelerated boundary wall .. is there any specific criteria to enhance the meshing ?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Foam::error::printStack(Foam::Ostream&) with simpleFoam -parallel	U.Golling	OpenFOAM Running, Solving & CFD	52	September 23, 2023 04:35
[ICEM] Negative volume error in hybrid mesh	siw	ANSYS Meshing & Geometry	4	September 3, 2014 06:25
Negative Volume during Mesh Motion Analysis	giov_ingr	FLUENT	2	December 13, 2013 07:09
channelFoam for a 3D pipe	AlmostSurelyRob	OpenFOAM	3	June 24, 2011 14:06
Help: Negative Volume	MANOJKUMAR	FLUENT	8	December 24, 2005 05:59

April 15, 2015, 08:04		#2
pumpkin New Member Marc Pelegri Join Date: Mar 2014 Posts: 5 Rep Power: 12	Try setting a really small time step, so that the mesh does not move more than a single cell.

April 15, 2015, 11:23		#3
wolverine New Member logan Join Date: Feb 2012 Posts: 10 Rep Power: 14	i tried lower time steps.. will mesh morphing helps??

April 16, 2015, 05:08		#4
pumpkin New Member Marc Pelegri Join Date: Mar 2014 Posts: 5 Rep Power: 12	I'm not sure mesh morphing will help. I suggest you to check where are your negative volumes. Try doing a plot of volume (with different iso-values). Then check if there are some left-handed cells. If so, I think you can repair them with in the command line with /grid/modify-zones/repair-face-handedness Hope this helps.