question about composition PDF transport model

lisa_china · November 22, 2014, 22:25

hello everyone,
recently i am simulating a jet burner with detailed chemical mechanism using PDF transport model. i have tried to use laminar finite rate-relax to chemical equilibrium as an initial solution, then using composition PDF transport to calculate the final result. but after the calculation, i found the velocity magnitude is much larger than the velocity i set, 10 times approximately.
i also have tried using partially premixed model to calculate as the initial solution, finally the velocity still was wrong.
please help me, so kind of you.
thank you in advance!

lisa_china · November 23, 2014, 10:15

please...
is there anyone who knows?

lucar4980 · November 23, 2014, 18:29

There should be something wrong...it cannot be just a modeling error. Check you BC again (Mass flow, temperatures, pressures, etc).

lisa_china · November 23, 2014, 20:59

hi Lucar,
i have checked my boundary conditions for several times, and they are right.
would you prefer to help me for another question?
should the particle velocity magnitude be the same as the velocity magnitude shown in the velocity contour?
thank you very much and hope for your rely.

November 22, 2014, 22:25	question about composition PDF transport model	#1
lisa_china Member Join Date: Oct 2014 Posts: 43 Rep Power: 12	hello everyone, recently i am simulating a jet burner with detailed chemical mechanism using PDF transport model. i have tried to use laminar finite rate-relax to chemical equilibrium as an initial solution, then using composition PDF transport to calculate the final result. but after the calculation, i found the velocity magnitude is much larger than the velocity i set, 10 times approximately. i also have tried using partially premixed model to calculate as the initial solution, finally the velocity still was wrong. please help me, so kind of you. thank you in advance! Last edited by lisa_china; November 23, 2014 at 10:12.

November 23, 2014, 18:29		#3
lucar4980 New Member Join Date: Oct 2012 Location: Italy Posts: 17 Rep Power: 14	There should be something wrong...it cannot be just a modeling error. Check you BC again (Mass flow, temperatures, pressures, etc). __________________ Advanced Mechanical Design CAE solutions specialist numerical.it

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Use of k-epsilon and k-omega Models	Jade M	Main CFD Forum	40	January 27, 2023 08:18
Question about scalar transport	osimonsimon	OpenFOAM Running, Solving & CFD	33	August 21, 2020 11:45
question about Heat transfer between two phases with VOF model	sooroo3	FLUENT	0	February 15, 2011 04:24
Eddy Viscosity Transport Model	Jade M	Main CFD Forum	0	April 21, 2010 15:17
DPM vs Species transport model	osh	FLUENT	0	August 19, 2005 23:15

November 23, 2014, 10:15		#2
lisa_china Member Join Date: Oct 2014 Posts: 43 Rep Power: 12	please... is there anyone who knows?

November 23, 2014, 20:59		#4
lisa_china Member Join Date: Oct 2014 Posts: 43 Rep Power: 12	hi Lucar, i have checked my boundary conditions for several times, and they are right. would you prefer to help me for another question? should the particle velocity magnitude be the same as the velocity magnitude shown in the velocity contour? thank you very much and hope for your rely.