 |
 |
 |
|
|
|
[Sponsors] | ||||
June 25, 2014, 02:59
|
Blockage ratio
|
#1 |
|
New Member
Saketh
Join Date: Jun 2014
Posts: 1
Rep Power: 0  |
Hello everyone,
1.What is blockage ratio? 2.What is the maximum allowable value for blockage ratio? 3.Does it(max value) vary depending on the geometry we choose? The simulation performed here is flow over a smooth sphere. Please do reply Thank you |
|
|
|
|
|
June 27, 2014, 22:35
|
|
#2 |
|
Senior Member
Lefteris
Join Date: Oct 2011
Location: UK
Posts: 341
Rep Power: 16 |
1. The ratio of the model's frontal area over the test section area.
2. I'm not sure but I think up to about 10%
__________________
Lefteris |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem with divergence | TDK | FLUENT | 13 | December 14, 2018 07:00 |
| [ICEM] Error in Prism Ratio Computed | singer1812 | ANSYS Meshing & Geometry | 0 | September 22, 2011 17:29 |
| pressure eq. "converges" after few time steps | maddalena | OpenFOAM Running, Solving & CFD | 69 | July 21, 2011 08:42 |
| diesel spray combustion equivalence ratio | usker | Siemens | 12 | March 1, 2008 07:09 |
| Problem of Turbulent Viscosity Ratio Limited | David Yang | FLUENT | 3 | June 3, 2002 07:13 |
Linear Mode
