|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Jun S. Kim
Join Date: Feb 2014
Posts: 2
Rep Power: 0 ![]() |
Dear folks.
I am currently doing free decay motion simulation with constant spring constant with dynamic mesh and UDF. initial displacement (physically pulling with initial amplitude) is made from UDF. After the initial displacement reached as it is designed, the fluid equation is on as the structure is moving. mesh motion only I found nice oscillatory behavior, and expect to observe damping effect on structure moving due to surrounding water. once fluid equation is on, I can see pressure spike at the beginning of transient and it is diverged. I think this kind of simulation is done with other tool (CFX, acusolve) by using ALE method. have anyone done water damping tightly coupled FSI problem simulation with fluent? any suggestion or sharing experience would be more than welcome. Thank you in advance. |
|
![]() |
![]() |
![]() |
Tags |
fsi, pressure spike |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mass imbalance problem in multiphase water and steam CFX case | Antech | CFX | 1 | October 26, 2020 04:03 |
No liquid water exist in my Fuel Cell simulation | fatchang | FLUENT | 19 | October 15, 2018 14:27 |
question about simulation of falling water film | mengyue1 | FLUENT | 2 | March 30, 2014 10:16 |
Simulation of water change | lkortela | CFX | 3 | February 23, 2014 16:50 |
Oil water separator in fluent | jinish | FLUENT | 0 | January 27, 2014 02:05 |