 |
 |
 |
|
|
|
[Sponsors] | ||||
April 7, 2014, 15:01
|
Problem with 2-d oscillating foil
|
#1 |
|
New Member
andrew graham
Join Date: Apr 2014
Posts: 2
Rep Power: 0  |
Hi,
I'm having a problem getting my 2-d foil to oscillate properly. I am varying the frequency in the code provided in this post. My problems are 1) its runs for around 60 iterations before a negative cell is detected. 2) When I look at the foil it doesn't look like, from the vortices that it has oscillated. 3) When the mesh is imported, the foil seems to be in the right place but when it has been simulated it seems to be right next to the pressure outlet? I can only see this being related to the code but am unsure how to solve it. 1.c rigidtail.c |
|
|
|
|
|
April 7, 2014, 15:03
|
|
#2 |
|
New Member
andrew graham
Join Date: Apr 2014
Posts: 2
Rep Power: 0 |
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem Importing Geometry ProE to CFX | fatb0y | CFX | 3 | January 14, 2012 20:42 |
| problem is modeling and simulation of an air foil | alnabhani | CFX | 4 | December 2, 2010 14:24 |
| Can I solve this problem by Fluent? | Kai_kc | FLUENT | 1 | October 27, 2010 06:29 |
| problem with oscillating cylinder | zonexo | FLUENT | 3 | September 14, 2006 11:13 |
| oscillating problem | Ning Yang | CFX | 1 | September 20, 2001 13:00 |
Linear Mode
