 |
 |
 |
|
|
|
[Sponsors] | ||||
March 21, 2014, 12:39
|
Moving heat source - UDF or not?
|
#1 |
|
Member
Robert
Join Date: Mar 2011
Location: Warsaw
Posts: 62
Rep Power: 15  |
Hello all!
I want to create a moving heat source and perform a 3D transient HT analysis. In order to do that I created a UDF that defines a moving heat flux boundary condition with gaussian distribution. The thing is that I want to use this boundary condition only in distance R from defined center of this distribution. The rest of a surface should have only convection on it. Is it possible to define changing of boundary conditions in a UDF? If not does anyone have any idea how to get this what I want? |
|
|
|
|
|
February 2, 2017, 06:09
|
|
#2 |
|
New Member
ARJUN A ASOK
Join Date: Feb 2017
Posts: 7
Rep Power: 9 |
I am doing my project work in ansys fluent weld pool simulation.Could you please
provide me with a udf for simulating a moving heat source in fluent |
|
|
|
|
|
 |
| Tags |
| heat flux, heat tranfer |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| what is swap4foam ?? | AB08 | OpenFOAM | 28 | February 2, 2016 02:22 |
| [swak4Foam] build problem swak4Foam OF 2.2.0 | mcathela | OpenFOAM Community Contributions | 14 | April 23, 2013 14:59 |
| Moving workpiece instead of Heat source Problem | ahmmedshakil | OpenFOAM Programming & Development | 1 | April 21, 2013 00:17 |
| UDF for heat source on surface instead of the whole cell zone?? | benson621 | Fluent UDF and Scheme Programming | 4 | December 8, 2011 12:54 |
| moving heat source | Mehdi | FLUENT | 0 | March 24, 2008 18:32 |
Linear Mode
