 |
 |
 |
|
|
|
[Sponsors] | ||||
March 10, 2014, 06:13
|
Tgrid meshing
|
#1 |
|
New Member
Ben Nicholls
Join Date: Oct 2013
Posts: 6
Rep Power: 13  |
Hi All I am modelling the flow of air around a bicycle wheel for my masters group project. I require to make the cells next to the wheel 0.001 x diameter high, how would i go about this? my wheel since it is to compare to a wind tunnel test has been scaled to a quarter and the geometry modified to allow for it to be mounted in the wind tunnel.
I am using the cutcell method in TGrid for this mesh. How would i go about setting this kind of mesh up? |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [GAMBIT] Error: small gap in meshing with Tgrid | gdebadrawada | ANSYS Meshing & Geometry | 1 | April 19, 2013 05:21 |
| using Tgrid meshing from gambit with FIdap | philippe | FLUENT | 0 | September 30, 2008 04:50 |
| meshing a wing with tgrid | sandeep varma | FLUENT | 2 | April 16, 2007 04:38 |
| Tgrid meshing around cylinders in GAMBIT | Chris | FLUENT | 3 | March 5, 2003 08:43 |
| TGRID & Meshing | Eric | FLUENT | 3 | February 13, 2002 11:52 |
Linear Mode
