 |
 |
 |
|
|
|
[Sponsors] | ||||
February 28, 2014, 01:09
|
steady state
|
#1 |
|
New Member
siddu
Join Date: Dec 2013
Posts: 11
Rep Power: 12  |
hi everyone
which model is good for steady state analysis of wing with mach no 0.8. thank u |
|
|
|
|
|
March 1, 2014, 08:53
|
|
#2 |
|
Senior Member
|
SA and SST are good choices. K-epsilon realizable will also give you good results if flow is not dominated by separation.
In addition to good turbulence models, mesh is also very important factor in getting results. So spend some time in getting good quality mesh with adequate resolutions. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 06:21 |
| Calculation of the Governing Equations | Mihail | CFX | 7 | September 7, 2014 07:27 |
| is it possible to predict how long it takes to reach steady state solution in unstead | Alimohamadi_nasr | CFX | 4 | November 11, 2013 07:11 |
| error message | cuteapathy | CFX | 14 | March 20, 2012 07:45 |
| Constant velocity of the material | Sas | CFX | 15 | July 13, 2010 09:56 |
Linear Mode
