 |
 |
 |
|
|
|
[Sponsors] | ||||
Tutorial about pressure inlet, pressure outletReverse flow in pressure inlet |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 26, 2014, 01:13
|
Tutorial about pressure inlet, pressure outletReverse flow in pressure inlet
|
#1 |
|
Senior Member
Tanjina Afrin
Join Date: May 2013
Location: South Carolina
Posts: 169
Rep Power: 13  |
Hello,
I am modeling a geometry ( A pipe surrounded by aggregate and pipe and aggregate are submerged by water) with pressure inlet and pressure outlet. I am getting reverse flow in inlet. I got a stable solution, reasonable residual, but reverse flow exists up to last iteration. I tried with single phase and VOF model. But I couldn't get rid of this reverse flow. Can anybody help? Does any body has any tutorial for pressure inlet-pressure outlet setup ? Thanks in advance. Regards, Tanjina |
|
|
|
|
|
| Tags |
| pressure inlet, reverse flow |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mass flow inlet and pressure outlet issue | nikhil | FLUENT | 5 | December 11, 2013 13:30 |
| Unsteady pressure differential between inlet and outlet of the pipe for single phase | joshi20h | FLUENT | 0 | September 26, 2012 13:41 |
| Maintaining Static Pressure at Fluid Flow Inlet | cdevalve | FLUENT | 3 | January 14, 2012 01:11 |
| Inlet pressure vs mass flow diference | Miroslav | CFX | 5 | March 24, 2011 00:34 |
| Reversed flow in pressure inlet | eric | FLUENT | 3 | January 26, 2004 21:04 |
Linear Mode
