How to setup simulation of injet Helium into Air cell zone?

Shogan · January 3, 2014, 21:49

Dear Fluentian,

I am new in the realm of Fluent and still reading the user guide.

Would you please inspire me how to setup to simulate helium is been injet into a cell zone with air inside? (Also there is another hole as pressure outlet)

I tried to chose species model (species transport or non-premixed combustion? )
Also I an in trouble when setting up the boundary condition. when setting the mass-flow-inlet boundary, the "species" option showed "this page in not applicable under current setting"

Oppsssss..... Please help, I tried the figure it out how to setup during this chrismas holiday, but so far no any progress

----Shogan

tt_1990 · December 10, 2014, 04:06

I have same problem with you. have you found solution yet

jwillie2000 · December 10, 2014, 07:29

If i remember correctly, you have to use mass source term and most likely a UDF to be able to inject into a specific cell in the flow Domain.

Read the Fluent Manual on how this is done. It might be helpful.

Jimmy

January 3, 2014, 21:49	How to setup simulation of injet Helium into Air cell zone?	#1
Shogan New Member Shogan Join Date: Jan 2014 Posts: 9 Rep Power: 12	Dear Fluentian, I am new in the realm of Fluent and still reading the user guide. Would you please inspire me how to setup to simulate helium is been injet into a cell zone with air inside? (Also there is another hole as pressure outlet) I tried to chose species model (species transport or non-premixed combustion? ) Also I an in trouble when setting up the boundary condition. when setting the mass-flow-inlet boundary, the "species" option showed "this page in not applicable under current setting" Oppsssss..... Please help, I tried the figure it out how to setup during this chrismas holiday, but so far no any progress ----Shogan

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Setting cell variable values in a fluid zone using UDF	eromon84	Fluent UDF and Scheme Programming	6	March 28, 2021 12:59
Error in solution using "Grid Interface"	agustinvo	FLUENT	4	January 20, 2015 13:03
Cell Zone definition in VOF Model	Jim87	FLUENT	0	May 8, 2013 11:55
[Other] cgnsToFoam problems with "QUAD_4" cells	lentschi	OpenFOAM Meshing & Mesh Conversion	1	March 9, 2011 05:49
Change cell zone index/thread during simulation	neilduffy1024	FLUENT	0	January 17, 2011 10:40

December 10, 2014, 04:06		#2
tt_1990 New Member dang son tung Join Date: Apr 2014 Posts: 3 Rep Power: 12	I have same problem with you. have you found solution yet

December 10, 2014, 07:29		#3
jwillie2000 Member James Willie Join Date: Mar 2009 Posts: 81 Rep Power: 17	If i remember correctly, you have to use mass source term and most likely a UDF to be able to inject into a specific cell in the flow Domain. Read the Fluent Manual on how this is done. It might be helpful. Jimmy