 |
 |
 |
|
|
|
[Sponsors] | ||||
Solution initialization accuracy initial values |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 5, 2013, 14:54
|
Solution initialization accuracy initial values
|
#1 |
|
New Member
Paja
Join Date: Dec 2013
Posts: 8
Rep Power: 13  |
Hi,
in solution initialization, when I set up to compute my initial values from my velocity inlet, I see the table of initial values with little bit different values. For example I used velocity 10m/s and there is 9,999993 m/s, the same with temperature I set up 293 K and there is displayed 292,9999 K. Does someone know why? Should I correct the accuracy somewhere? Thanks! Paja |
|
|
|
|
|
| Tags |
| accuracy, initial values, solution initialization |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 07:20 |
| Why RNGkepsilon model gives floating error | shipman | OpenFOAM Running, Solving & CFD | 3 | September 7, 2013 09:00 |
| why divergence occures in these cases | immortality | OpenFOAM Running, Solving & CFD | 2 | January 25, 2013 11:21 |
| pisoFoam with k-epsilon turb blows up - Some questions | Heroic | OpenFOAM Running, Solving & CFD | 26 | December 17, 2012 04:34 |
| Negative value of k causing simulation to stop | velan | OpenFOAM Running, Solving & CFD | 1 | October 17, 2008 06:36 |
Linear Mode
