using sliding meshes

sairam123 · November 28, 2013, 13:06

hi there!!
I am trying to simulate two trains passing each other in fluent using slidingmesh. since i havent had any past experience in sliding mesh, i would like some help in setting up the problem..
If, by chance anyone has fluent case file of this kind of problem, please email me

like.no.other · November 29, 2013, 04:47

hi
you should define two zones and interface boundary condition between them

sairam123 · November 29, 2013, 11:43

thank you for the response.. yes i have created an interface and defines two cell zones. Now u am able to run a 2D model but i'm not getting the desired results. i think i'm doing something wrong in defining the velocities of the moving cell zones and my train model which i defined as wall. could you help me in figuring out this ??

November 28, 2013, 13:06	using sliding meshes	#1
sairam123 New Member sairam Join Date: Oct 2013 Posts: 7 Rep Power: 13	hi there!! I am trying to simulate two trains passing each other in fluent using slidingmesh. since i havent had any past experience in sliding mesh, i would like some help in setting up the problem.. If, by chance anyone has fluent case file of this kind of problem, please email me

November 29, 2013, 04:47		#2
like.no.other Member like.no.other Join Date: Sep 2011 Posts: 35 Rep Power: 15	hi you should define two zones and interface boundary condition between them __________________ www.CFDiran.ir

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Using sliding meshes (AMI) without imposing a fixed rotation	hakonbar	OpenFOAM Running, Solving & CFD	0	April 2, 2013 07:41
CFD of propeller with sliding meshes	ivanddd	Main CFD Forum	1	April 19, 2011 14:30
sliding meshes	Tim Daly	FLUENT	3	November 20, 2008 09:20
sliding meshes with periodic BC's	Dan Brozozowski	FLUENT	3	June 27, 2003 08:10
Empty surface in sliding meshes.	Pierre Ricco	FLUENT	2	March 14, 2001 17:01

November 29, 2013, 11:43		#3
sairam123 New Member sairam Join Date: Oct 2013 Posts: 7 Rep Power: 13	thank you for the response.. yes i have created an interface and defines two cell zones. Now u am able to run a 2D model but i'm not getting the desired results. i think i'm doing something wrong in defining the velocities of the moving cell zones and my train model which i defined as wall. could you help me in figuring out this ??