Introduce a perturbation during a simulation

ziggo · November 25, 2013, 21:07

In this article on unsteady CFD analysis of von Karman vortex shedding the following is said on page 3, section 2.3:

Quote:

When the steady state solution is achieved within about 80 time steps, a jet normal to the mean flow direction is introduced in the vicinity of the trailing edge during 10 time steps.

This is done to accelerate the occurrence of the vortex shedding.
How do I introduce a local jet normal to the flow in Fluent for a certain amount of time steps?

macfly · November 26, 2013, 13:14

Implement a DEFINE_PROFILE udf where the inlet velocity profile is dependent on the flow time with some conditional statements.

For an example of DEFINE_PROFILE and flow time, look for "UDF for specifying a transient pressure profile boundary condition" in the Ansys Fluent UDF Manual. Then look for "if-esle statement" in the same manual.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Solar Radiation in OpenFOAM	plainstyle	OpenFOAM Running, Solving & CFD	15	July 8, 2014 05:43
Simulation of a complex wing in solidworks flow simulation	niels1900	FloEFD, FloWorks & FloTHERM	6	April 20, 2011 11:44
Use mesh motion to introduce angle for static simulation	dancfd	OpenFOAM Running, Solving & CFD	1	November 18, 2010 20:15
GUI crash and simulation engine still running	RPJones	FLOW-3D	2	November 9, 2010 09:18
strange simulation error	Ralf Schmidt	FLUENT	2	May 4, 2007 14:02

November 26, 2013, 13:14		#2
macfly Senior Member François Grégoire Join Date: Jan 2010 Location: Canada Posts: 392 Rep Power: 17	Implement a DEFINE_PROFILE udf where the inlet velocity profile is dependent on the flow time with some conditional statements. For an example of DEFINE_PROFILE and flow time, look for "UDF for specifying a transient pressure profile boundary condition" in the Ansys Fluent UDF Manual. Then look for "if-esle statement" in the same manual.