 |
 |
 |
|
|
|
[Sponsors] | ||||
October 25, 2013, 05:17
|
Display of Phase Graphic
|
#1 |
|
New Member
Kai Ling
Join Date: Sep 2013
Posts: 8
Rep Power: 13  |
Hi, I am working on a 3D simulation of a box dropping into a tank of water in FLUENT. After setting up all the boundary conditions and patching, I went to Graphics and Animations to check whether I have patched properly. While the partition of the water and air is correct, there were empty patches all around. In the picture below, the top view of the model is shown. Could anyone enlighten me on why these patches had surfaced? And would this affect my data collected?
Thank you  
|
|
|
|
|
 |
| Tags |
| fluent, graphics |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| alphaEqn.H in twoPhaseEulerFoam | cheng1988sjtu | OpenFOAM Bugs | 15 | May 1, 2016 17:12 |
| [OpenFOAM] Xlib: extension "GLX" missing on display | goldbeard | ParaView | 5 | March 24, 2013 14:12 |
| Display vapor/liquid phase | Annka | FLUENT | 1 | September 7, 2012 09:51 |
| errors when installing openfoam2.1 on ubuntu12.o4 | hewei | OpenFOAM Installation | 5 | May 29, 2012 08:43 |
| compressible two phase flow in CFX4.4 | youngan | CFX | 0 | July 2, 2003 00:32 |
Linear Mode
